FREQ Matrix Quad System Menu
ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 7
ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 8
FREQ Matrix Quad System Menu
ADDR
-
DMX Address Setting
via control board -
1. Press the MENU button until “ADDR” is displayed, press
ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least
3 seconds.
CHND -
This will let select your desired DMX channel
mode.
1. Press the either the MENU button until “CHND” is displayed,
press ENTER. Either “2CH”, “5CH”, “18CH” or “64CH” will be
displayed
2. Press the UP or DOWN buttons to find your desired DMX
channel mode and press ENTER to confim and exit.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until “SLND” is displayed, press
ENTER. Either “SL 1” or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Slave 1 (SL 1) and then set the next fixture to Slave 2 (SL 2),
in doing this the fixtures will now have contrast movement to
each other.
SHND: SH 0
-
SH 8
- Show modes 0 - 8
