©
American DJ
®
- www.americandj.com - Emerald Beam™ Instruction Manual Page 7
Emerald Beam™
Control & Functions
1. Audio Sensitivity Knob -
This adjust audio sensitivity of the
internal microphone (2). Turning the sensitivity knob in the clockwise
direction will increase the sensitivity to sound. Turning the knob in
the counter clockwise direction will decrease the fixture’s sensitivity
to sound.
2. Microphone -
This microphone receives external low frequencies
to trigger the unit in Sound-Active mode. This microphone is designed
to receive low frequency sounds only, tapping on the microphone and
high pitch sounds may not trigger the unit.
3. Power Cord Connection -
This connection is used to supply main
power to the fixture. Use only the supplied I.E.C. power cord. Be sure
the main power matches the required power of your fixture.
4. Fuse Holder -
This housing stores the 2 amp GMA protective
fuse. Always replace with the exact same type fuse, unless other
wise instructed, by an authorized American DJ
®
service technician.
Emerald Beam™
Operation
CAUTION IMPORTANT! When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Power Supply:
This unit is available in both 120v and 220v options,
before plugging your fixture in be sure the source voltage in your area
matches the required voltage for your American DJ
®
Emerald Beam.™
General Operation:
Plug and Play operation
. This fixture is
designed to operate as a stand alone unit to sound. The Emerald
Beam™ is ready to be plugged in, out of the box, there is no power
switch. After plugging the fixture in the laser will immediately begin to
cycle through the many built in programs. The programs cycle through
automatically when the unit is operating and may not be selected
manually. The unit requires sound to operate and will automatically
blackout without sound to conserve laser life. If the unit does not turn
on after the unit has been plugged in, be sure the sound sensitivity is
tuned up (1), fuse has not blown, and the unit is properly plugged in to
a matching wall outlet. If problem continue to persist, please contact
customer support for further instructions.
Sensitivity Knob:
A sound sensitivity knob is located on the rear of
the unit. Use this knob to regulate the amount of sound it takes to trig-
ger the unit. Turning the knob in a clockwise direction will increase the
units sensitivity to sound, turning the knob in a counterclockwise direc
-
tion will decrease the units sensitivity. Turning the knob completely to
the counter-clockwise direction will turn off the sound-active mode.
SOUND
MIN
MIN
LEVEL
FUSE
AC 100-120V
AC 200-240V
Model : Emerald Beam
Serial No : ____________
Power : ___________
Fuse : ___________
Bulb : ___________
DANGER
VISIBLE LASER RADIA
TION
-A
VOID DIRECT
EYE EXPOSURE
LASER DIODE
WAVELENGTH : 532 nm
Max Output : <4.9mW
Class IIIa Laser Product
1
4
3
2
©
American DJ
®
- www.americandj.com - Emerald Beam™ Instruction Manual Page 8
