©
American DJ Supply
®
- www
.americandj.com - Cross Flash™ Instruction Manual Page 4
©
American DJ Supply
®
- www
.americandj.com - Cross Flash™ Instruction Manual Page 3
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit.
These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future ref-
erence.
Cr
oss Flash™
General Instructions
Cr
oss
Flash™
Pr
ecautions
Safety Issues:
This unit may blow a fuse if the maximum allotted
load of 3 amps is reached. If the fuse needs replacement, always
replace the fuse with same exact type that was remove, unless other-
wise instructed by an authorized
American DJ
®
service technician. Use
of a dif
ferent type fuse from that which is recommended may cause fire
or electric shock and will void the manufactures warranty.
•
Keep the outside of this device dry at all times. Do not spill water or
other liquids into or on to your unit.
T
o
prevent fi
re or shock hazard,
do not expose this product to rain or moisture.
•
Be sure to save the packing carton in the event you may have to
return the unit for service.
•
This unit is designed for interior use only. Do not use this unit out
doors. Use of product outdoors will void the warranty.
•
Be sure that the local power outlet match that of the required volt-
age for your unit.
•
Do not attempt to operate this unit if the power cord has been
frayed or broken.
•
Always route your power cord out of the way of foot traffi
c.
•
Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fi
re in the rare case of an internal short.
•
Disconnect the unit’s main power when left unused for long periods
of
time.
•
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
•
Never block the ventilation holes.
•
Do not attempt to operate this unit, if it becomes damaged in any
way.
•
Never operate this unit when it’s cover is removed.
•
This unit is for adult use only. Keep out of the reach of children.
Cr
oss Flash™
Operation
Power
Supply:
Before
plugging
your
unit
in,
be
sure
the
source
voltage in your area matches the required voltage for your
American
DJ
®
Cross Flash™ before attempting operation.
General
Operation:
Just
plug
this
light
in,
and
watch
it
go.
This
fixture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary.
The Cross Flash™ is ready to be plugged in, out of the
box.
There
is
no
power
switch,
after
plugging
the
unit
the
unit
will
slowly
light
up
and
rotate
in
a
single
direction.
If
there
is
no
lamp
output check the fuse and bulb. If the fuse and bulb are good, please
return the unit for servicing.
Sensitivity Knob:
A
sound sensitivity knob is located on the rear of
the unit. Use this knob to control amount of sound it takes to trigger
the
unit.
T
urning
the
knob
in
a
clockwise
direction
will
increase
the
units
sensitivity
to
sound,
turning
the
knob
in
a
counterclockwise
direction will decrease the units sensitivity to sound.
•
6 Colors / 6 Beams at Once
•
Wide Beam Spread
•
Easy Lamp Replacement
•
Compact Case Design
•
Built-In Hanging
Y
oke
•
Bright 300 W
att Lamp
•
Internal Microphone with Sound Sensitivity Knob
•
Fan Cooled
Cr
oss Flash™
Featur
es
Cr
oss Flash™
Halogen Lamp W
a
r
ning
This fixture is fitted with halogen lamps which are
highly susceptible to damage if improperly handled.
Never
touch
the
lamps
with
your
bare
fingers
as
the oil from your hands will shorten lamp life.
Also,
never
move
the
fixture
until
the
lamps
have
had
ample time to cool. Remember
, lamps are not cov-
ered under warranty conditions.
