Replacing the Transformer Switch
1. Disconnect the mixers main power supply
2. Using a number two Phillips screw driver, unscrew the two larger stainless steel retain screws
on the outside corners of the selector switch. These screws hold the selector switch in place.
3. Gently remove the selector switch from its seated position.
4. After removing the selector switch, disconnect the ribbon cables that attach the selector switch
to the PC board. Grasp the selector switch by its base and pull the ribbon cables by their
connectors not the actual cables. The connector are color code and only fit one way, so don't
worry about the connectors orientation.
5. With the selector switch remove and the ribbon cables disconnected, use a number one Phillips
screw driver to remove the switch from its cover.
6. Connect the new selector switch to the ribbon cables and replace in reverse order.
Changing the Transformer Switch Position
1. Disconnect the mixers main power supply
2. Using a number two Phillips screw driver, unscrew the two larger stainless steel retain screws
on the outside corners of the selector switch. These screws hold the selector switch in place.
3. Gently remove the selector switch from its seated position.
4. After removing the selector switch, turn the unit to your desired position.
5. Replace in reverse order.
The sector switch may be oriented several different position. This will allow
for versatility and comfort when scratching.
©
American DJ Supply
®
- www.americandj.com - Q-2221/X User Instructions page 9
