©
American Audio
®
- www.americanaudio.com - WM-64™ Instruction Manual Page 7
WM-64™
LAvALIER OPERATION
Receiver Set Up
1. Plug the included power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the power supply into an power outlet.
Note: Make sure the squelch on the receiver is turned the minimum.
Lavalier Set Up
1. Insert two AA batteries into the back battery compartment of the lavalier bodypack.
2. Connect the headset to the bodypack via the attached mini XLR cable. Make sure the Gain con-
trol located on the bottom right side of the bodypack is set to a minimum level.
Connecting the Receiver Output
1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR
female connection.
2. Connect one end of the cable to the receiver, and the other end into the mic input of a mixer, PA
system, or amplifier. Set the Mic/Line switch accordingly on both the receiver and lavalier.
WM-64™
LAvALIER SYSTEM SET UP
1. Plug the receiver in and press the power button for at least 2 seconds to turn on the receiver.
N
ote: Make sure the squelch on the receiver is turned the minimum before switching on the
power.
2. Select the channel. There are two ways to set the Channel.
- Press and hold the SET/SCAN button for 3 seconds to auto search for the next clear channel.
- Press the SET/SCAN button for 1 second it will start to flash. Press the UP button to switch to
the next group of numbers and the DOWN button to select your desired channel in the group.
After you have found your desired channel allow the LCD to stop flashing and your channel will
be locked into the receiver.
3. Switch the power to “On” on the top of the lavalier. Set the lavalier channel to the same channel
as the receiver. The channel setting is located on the side of the bodypack. There are two turn
dials if you are setting to a two digit channel number, the top dial is the first digit and the bottom
dial is the second digit. If the signal from the lavalier is being received by the receiver the RF LED
should light up.
4. Speak, sing, or play your instrument at a typical level. The AF LED’s should flicker when receiving
a signal from the lavalier.
5. When finished, switch the lavalier “Off”. Then press the power button on the receiver for 2 sec-
onds to turn it “Off”.
