©
American Audio
®
- www.americanaudio.com - WM-64™ Instruction Manual Page 6
WM-64™
OPERATION
1. Plug the receiver in and press the power button for at least 2 seconds to turn on the receiver.
Note: Make sure the squelch on the receiver is turned the minimum before switching on the
power.
2. Select the channel. There are two ways to set the Channel.
- Press and hold the SET/SCAN button for 3 seconds to auto search for the next clear channel.
- Press the SET/SCAN button for 1 second it will start to flash. Press the UP button to switch to
the next group of numbers and the DOWN button to select your desired channel in the group.
After you have found your desired channel allow the LCD to stop flashing and your channel will
be locked into the receiver.
3. Press the power button on the mic located at the bottom for 2 seconds to turn on the mic. Set
the mic channel to the same channel as the receiver. The channel setting is located on the other
side of the battery compartment. There are two turn dials if you are setting to a two digit channel
number, the top dial is the first digit and the bottom dial is the second digit. If the signal from the
mic is being received by the receiver the RF LED should light up.
4. Speak, sing, or play your instrument at a typical level. The AF LED’s should flicker when receiving
a signal from the microphone.
5. When finished, turn the mic “Off” by pressing the power button for 2 seconds. Then press the
power button on the receiver for 2 seconds to turn it “Off”.
Note: If you have rechargable batteries installed in the mic, you can connect the supplied
cable to the DC out located on the front of the receiver to the input jack on the bottom of the
mic and recharge the batteries.
Receiver Set Up
1. Plug the included power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the power supply into an power outlet.
Note: Make sure the squelch on the receiver is turned the minimum.
Microphone Set Up
1. Unscrew the bottom part of the microphone. The battery compartment is located inside of the
microphone. Insert two AA batteries.
2. Screw the bottom of the microphone back into place.
Connecting the Receiver Output
1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR
female connection.
2. Connect one end of the cable to the receiver, and the other end into the mic or line input of a
mixer, PA system, or amplifier. Set the Mic/Line switch accordingly on the receiver.
WM-64™
MICROPhONE SYSTEM SET UP
amplifier set the switch to “Mic”.
13. Unbalanced 1/4” Output -
This unbalanced output can be used to connect the receiver to the
line-level input of a mixer or amplifier.
14. Balanced XLR Output -
This balanced XLR output can be used to connect the receiver to bal-
anced input of mixer or amplifier.
WM-64™
RECEIvER CONTROLS ANd FUNCTIONS
