Turntable Assembly:
1. REMOVING FROM CARTON:
Carefully remove the main unit with the packing material intact from the box.
Remove the packing material once the unit has been removed from the shipping
carton. Be sure to locate all the accessories located in the packing material.
2. 45 ADAPTER:
Locate and remove the 45-rpm adapter from the packing material and place it in
the 45 adapter cut out on the top of the main unit.
3. TURNTABLE PLATTER :
Remove the turntable platter from the packing material and gently insert the
platter into the
CENTER SPINDLE
on the base of the turntable unit.
4. SLIPMAT:
Remove the black slipmat from the packaging and place it on the
PLATTER
.
5. HEADSHELL:
Insert the
HEADSHELL
into the front end of the
TONEARM ASSEMBLY
. While
holding
HEADSHELL
firmly into the front end of the tonearm assembly, turn the
HEADSHELL LOCKING NUT
counter-clockwise to firmly secure the
HEADSHELL
to
TONEARM ASSEMBLY.
HEADSHELL
TONEARM ASSEMBLY
HEADSHELL LOCKING NUT
HEADSHELL
6. COUNTERWEIGHT :
TONEARM ASSEMBLY
COUNTERWEIGHT
COUNTERWEIGHT :
Locate and remove the tonearm
COUNTERWEIGHT
from the packaging. Slide
COUNTERWEIGHT
onto the rear of the
TONEARM ASSEMBLY
. Turn it lightly
and it will screw onto the rear shaft of the tonearm.
Turntable Connections:
1. Connect the unit's stereo output leads to a receiver or mixer. The red phono
terminal represents the right output channel and the white terminal represents
the left output channel.
2. The thin black wire with a spade connector is the ground lead. The ground
lead must be connect to the mixer (receiver) to avoid pops and clicks associated
with magnetic pick-up system such as turntables.
Output Leads
Mixer (Receiver)
L (White)
-----------------------------> L Channel
R (Red)
------
----------
-
-
-
-
--
-
-
-
--
-
-> R Channel
GND (Spade) ----------------------------> Ground
American Audio
TTD-2400 USB
Instruction Manual
Page 9
