15. AC VOLTAGE SELECTOR -
This switch is used to adjust the operating voltage. Operating voltage
can be toggled between 115V/50Hz or 230V/60Hz. Always be sure the selector is set to the proper
voltage for your area before attempting to operate the unit.
16. PLAYER CONTROL -
These jacks are used to control the “Q-Start” function between the mixer and
a compatible American Audio CD Player. Input mini plugs from CD player controller into these jacks,
input CD 1 into jack A and CD 2 into jack B.
17. LIGHT CONTROL -
This jack provides a preset mono audio signal output. There is no way to adjust
this level, however this level will directly refl ect the output level of the
Channel Faders (3)
. This buffered
audio output should only be used for light controllers that can accept an external audio input. Great for
Touch Panels and Chase Controllers. Buffered audio output for light controllers that can use external
input.
18. DJ MICROPHONE CONNECTOR -
This jack is used to a connect a microphone to the mixer. Con-
nect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the
DJ Mic Knob
(7)
. The bass and treble levels can also be adjusted by the built-in microphone EQ (7).
19. AC CONNECTION -
This connector is used to supply main power to the unit. Use only the supplied
detachable AC power cord.
20. RCA MASTER OUTPUTS -
The Master Output includes a pair of RCA Unbalanced Jacks. The RCA
jacks send a low current unbalanced output signal.
Rear Panel
Q-221™
Controls and Features Cont.
©
American Audio
®
- www.americandj.com - Q-221™ Instruction Manual Page 7
19
25
24
23
22
21
20
18
17
16
15
27
26
