1. MICROPHONE EQ SECTION -
MIC GAIN CONTROL -
This knob controls the output volume of the Microphone. However, master
volume is controlled by the MASTER VOLUME CONTROL (5).
MICROPHONE TREBLE CONTROL -
This knob is used to adjust the treble levels of the Micro-
phone with a maximum signal gain of 12dB or maximum signal decrease of -12dB. Turning the knob
in a counter-clockwise direction will decrease the amount of treble applied to the microphone signal,
turning the knob in a clockwise direction will increase the amount of treble applied to microphone
signal.
MICROPHONE BASS CONTROL -
This knob is used to adjust the low frequency levels of the
microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB. Turning the
knob in a counter-clockwise direction will decrease the amount of bass applied to the microphone
signal, turning the knob in a clockwise direction will increase the amount of bass applied to micro-
phone signal.
MIC ON/OFF -
This button will activate and deactivate the Microphone.
2. CHANNEL EQ, LPF/HPF FILTER, & CHANNEL VOLUME FADER -
CHANNEL GAIN CONTROL -
This adjustment is used to adjust the audio source signal input gain
for a channel. Never use the gain control to adjust a channels output volume. Setting the gain level
properly will ensure a clean output signal. An improper gain level adjustment will send a distorted
signal throughout the entire audio line which may damage speakers and amplifiers. To properly set a
channels gain level control:
1. Be sure the MASTER VOLUME CONTROL (5) is set to level 8.
2. Set the CHANNEL FADER to level 8.
3. Begin playback on an audio source connected to the channel you are adjusting.
4. Use the Gain Control to adjust an average output volume of +4 dB.
5. Repeat this step for all channels.
CHANNEL TREBLE CONTROL -
This knob is used to adjust the treble levels of a channel allowing
for a maximum treble gain of 12dB or maximum decrease of -∞dB. Turning the knob in a counter-
clockwise direction will decrease the amount of treble applied to a channel signal, turning the knob in
a clockwise direction will increase the amount of treble applied to a channel signal.
CHANNEL MIDRANGE CONTROL -
This knob is used to adjust the midrange levels of a channel
allowing for a maximum midrange gain of 12dB or maximum decrease of -∞dB. Turning the knob in a
counter-clockwise direction will decrease the amount of midrange applied to a channel signal, turning
the knob in a clockwise direction will increase the amount of midrange applied to a channel signal.
CHANNEL BASS CONTROL -
This knob is used to adjust the low frequency levels of a channel
allowing for a maximum bass gain of 12dB or maximum signal decrease of -∞dB. Turning the knob in
a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning the
knob in a clockwise direction will increase the amount of bass applied to a channel signal.
LPF/HPF CONTROL - This knob is used to control the LPF/HPF filter. The LED indicator will glow
when the filter is On. The center position for the Filter is neutral so the signal is will not be filtered. Turn
the knob to the left from the neutral position to set the low pass filter, this will cut off all frequencies
higher than the amount set on the filter. Turn the knob to the right from the neutral position to set the
high pass filter, this will cut off all frequencies lower than the amount set on the filter.
CHANNEL VOLUME FADER - These faders are used to control the output signal of any source
10MXR
CONTROLS AND FUNCTIONS cont.
©
American Audio
®
- www.americanaudio.us - 10MXR Instruction Manual Page 9
