©
American Audio
®
- www.americanaudio.us - 10MXR Instruction Manual Page 12
10MXR
CONTROLS AND FUNCTIONS cont.
13. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of
the two available ground terminals. This will reduce the humming and popping noises associated
with magnetic phono cartridges.
14. MICROPHONE CONNECTOR - This jack is used to a connect a microphone to the mixer. Con-
nect you microphone via this 1/4 inch (6.3mm) jack. The volume output level for this microphone will
be controlled by its own respective MICROPHONE GAIN CONTROL (1). Note: We recommend that
you use a 500-600ohm microphone for the best sound quality.
15. CHANNEL 1: INPUTS - The type of input must directly reflect the selected mode of the CHAN-
NEL LINE LEVEL SELECTOR SWITCH (16). CD players, Tape Decks and other line level instruments
may be connected to these jacks. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Input volume will be controlled by channel three fader.
The channel SOURCE SELECTOR SWITCH (3) must be in the “Analog” position, to monitor any
source connected to these jacks. Turntables equipped with MM pickup cartridge (All DJ turntable
use MM pick-up cartridges) may be connected to these jacks as long as the CHANNEL LINE LEVEL
SELECTOR SWITCH (16) is in the “PHONO” position. When CD players, Tape Decks and other line
level instruments are connected to these jacks the CHANNEL LINE LEVEL SELECTOR SWITCH (16)
is in the “LINE” position. Never connect line level instruments (CD players, tape decks, etc.) to these
jacks when the CHANNEL LINE LEVEL SELECTOR SWITCH (16) is in the “PHONO” position, THIS
MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel
input and the white represents the left channel input. The channel SOURCE SELECTOR SWITCH (3)
must be in the “Analog” position, to monitor any source connected to these jacks.
16. CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt-
age line levels of there respected Phono / Line RCA inputs jacks. When connecting turntables with
magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position,
and when using line level input devices be sure this switch is in the “LINE” position. Always be sure
REAR PANEL
17 16
13
18
14
15
22
21
20
19
23
