©
American Audio
®
- www.americanaudio.us - M2436FX Instruction Manual Page 13
M2436FX
MaiN CONTROLS aNd FUNCTiONS cont.
the frequency response of the MAIN stereo mix bus signal. Each frequency band has a max boost/cut
of 12db. This Eq is also very useful in cutting the frequencies that cause annoying feedback. The
MAIN gRAPHIC Eq is stereo, therefore the Eq curve is applied to both the left and right signal at main
output.
27. MAIN EQ ON/OFF BUTTON -
This function is used to activate or bypass the MAIN EqUALIZER
.
When the button is pressed “In”, the Eq is active, when the button is “Out”, the Eq is bypassed.
28
.
LEVEL METER -
This LED
displays the signal level of the selected LEVEL METER SIgNAL bUTTON
(31)
.
When the meter lights up RED then the output is hitting the clipping level.
29. MASTER SEND CONTROLS -
AUX 1 & AUX 2 CONTROL kNObS - Use the corresponding knobs to adjust the level of the signal
output sent AUX 1 or AUX 2 JACkS.
MASTER EFFECT CONTROLS -
Use this knob to adjust the signal level of the EFFECT bus sent to the
EFFECT JACk.
30
.
CONTROL ROOM/HEADPHONE CONTROL -
This controls the signal level that is sent to the
CONTROL ROOM JACkS or HEADPHONE JACk.
31. LEVEL-METER SIGNAL BUTTONS -
Use these buttons to select the signal that is sent to either
the CONTROL ROOM OUTPUTS or the HEADPHONE OUTPUT . The ouput level will be shown in the
LEVEL METER.
(1).
If the
channel’s PFL button is pressed “In”,
then
ONLY
the channel’s PFL output is sent
to either the CONTROL OUT JACkS or HEADPHONE JACk.
(2).
If the
channel’s PFL button is “Out”,
then either the MAIN L/R or gROUP 1-2/3-4, signal
is sent to either the CONTROL JACkS or HEADPHONE JACk.
32. TO MAIN BUTTONS -
When this button is pressed “In”, the mixer will send the signal processed
by the gROUP faders to the MAIN L/R bus. The gROUP 1 & 3 signal goes to MAIN L and gROUP 2
& 4 signal goes to MAIN R.
33. MAIN L/R FADERS -
This fader adjusts the final signal level sent to the MAIN L/R OUTPUT
JACkS.
