Amedia HK Ltd. Wireless Multimedia Connectivity Solutions
3.2 Connect the AV Receiver to an A/V Display
Step 5: Connect one end of the A/V cable (RCA or S-Video) to the audio (2F, 2G), and video (2H for
RCA and 2J for S-video) output jacks, and connect the other end of the A/V cable to the
display device via its “AV input ”.
Step 6: Keep the IR window oriented toward front when using your source device’s remote
controller.
Step 7: Power on the AV Receiver by connecting the DC plug of the Power Adapter to the DC jack
(2K), and connect the power supply to an outlet.
Step 8: The Power on LED (2A) shall be on, the Link LED (2B) shall start blinking.
Step 9: The Link LED (2B) shall stop blinking and stay in solid in less than 5 minutes. By then, the
wireless link is successfully established.
4. Trouble Shooting
After plug the power, the Power on LED (1A or 2A) is not on?
Check the power outlet and make sure the power is on. Then unplug the DC supply from the DC
jack (1K or 2K) and plug it back on. Repeat this a few times if problem persists.
During the setup, what if the Link LED (1B or 2B) keeps blinking and doesn’t turn solid on?
This indicates the wireless link is not up yet. Check both AV Sender and AV Receiver to make sure
they are both power on. If the problem still persists, do following steps:
Step 10: Go to the AV Sender. Press (and release) the Paring button (1E). The Pairing LED (1C)
shall be on.
Step 11: Go to the AV Receiver. Press (and release) the Paring button (2E). The Pairing LED
(2C) shall be on. It shall quickly go off after the Link LED (2B) stop blinking and stay
solid on.
Note: the Pairing LED will go off in 45 seconds if there is no wireless link.
If the Link LED continues blinking after Step 10 and 11, you may have to move the AV Receiver
closer to the AV Sender and try the setup again.
After the wireless link established, what if the AV Receiver’s Link LED (2A) changes from
solid on to blinking or even off?
This indicates the loss of the wireless link. If the link cannot recover in 5 minutes, reset the power of
the AV Receiver.
5
