AMD ATI TV Wonder 650 PCIe, User Manual

Page: 12 / 20

7.
Reconnect any cables you have disconnected, and then plug in the
computer’s power cord.
8.
Connect your TV and, optionally, FM radio input sources to the connectors
on the backplate of your tuner:
➭
For over-the-air digital TV, connect a DTV antenna to the
ANT IN
connector.
➭
For analog TV or FM, connect either your cable TV coaxial cable or an
FM antenna to the
TV IN
connection.
9.
Turn on the monitor, and then your computer.
If you have properly installed your card, operating system messages will appear
once the boot procedure is finished. Proceed with the installation of drivers and
software.
Software Installation
Installation Steps
Note:
•
You must install or reinstall the drivers and software in the following
cases:
•
After you have installed the card in your system.
•
After you have reinstalled or upgraded your operating system.
•
To install or remove the drivers, you must be logged on as a user with
administrator rights. We also recommend that you have the latest
Windows® Service Pack installed.
The following steps guide you through the installation of your software.
1. With your tuner installed, start your system.
2. When the
Found New Hardware Wizard
comes up, click
Cancel
. When the
System Settings Change
window asks you to restart your computer, click
No
.
3.
Run the
ATISETUP
utility. The
ATISETUP
utility will start automatically if you
insert the ATI Installation CD into your CD drive after the operating system
has started. If your CD autorun is not enabled or the
ATISETUP
utility does
not start automatically follow these steps:
a.
In the Windows® task bar, click the
Start
button.
b. Click
Run
.
c. In the
Run
dialog, type
X:\ATISETUP.EXE
(where X: is your CD/DVD
drive). The Install screen opens.
The setup and install screeens are displayed in English if your operating
system's language is not supported
4.
In the Install screen, click
Software Install
.
6
Installation
ATI TV Wonder™ 650 PCIe © 2007 AMD
P/N 137-71119-20