Amcon Auto Chart Projector
5. Operating Procedures
Caution:
Do not tilt the projector or place in an unstable place. The
projector may topple over, drop or cause injury.
Warning:
Connect the power plug to a properly grounded three-prong
AC outlet. If it is connected to an ungrounded outlet, fire and/or
electrical shock may result.
Caution:
Handling the power plug with wet hands can cause electric
shock.
5.1 Preparation
1. Place the instrument approximately level to the person to be tested.
2. Turn the power switch ‘off’.
3. Insert the power cord into the power socket on the projector body and plug into
the wall outlet.
4. Turn the power switch ‘on’.
5. Remove the battery cover from the back of the remote controller.
6. Insert batteries into the remote controller as illustrated and replace the battery
cover.
7. Adjust the position of the projector so that the projector light is centered on the
screen. Be sure the projector is in the position from which it will be used.
8. To focus the projector, slide the focusing knob that is found on the underside of
the projector base. (The same side as the lamp cover.) There is a barrel screw
that must be loosened before the knob can be moved. The enclosed Allen
wrench can be used to loosen or tighten this screw.
12