USING THE ANTI-TAMPERING DEVICE
Make a hole with a diameter greater than that of
the wedge that will be used for such protection
on the bottom of the cover, refer to the hole
pattern on the side. Insert the plug into the wall
and tighten the screw leaving out just enough to
ensure the closing of the microswitch on the
back of the PCB.
SPECIFICATIONS:
Input voltage
9 to 15 Vdc
Average current drain
25 mA @ 13.8 Vdc
Maximum current drain
30 mA @ 13.8 Vdc
Operating temperature
From -24 °C to + 60°C
Storage temperature
From -24°C to + 60 °C
Cover
ABS
Dimensions
120 x 140 x 35 mm
Grado protezione
IP34
Our products/systems comply with the essential requirements of EEC directives. Installation must be carried out following
the local installation norms by qualified personnel.
The manufacturer refuses any responsibility when changes or unauthorized repairs are made to the product/system.
It is recommended to test the operation of the alarm product/system at least once a month. Despite frequent testing and
due to, but not limited to, any or all of the following: tampering, electrical or communication disruption or improper use, it
is possible for the product/system to fail to prevent burglary, rubbery, fire or otherwise. A properly installed and maintained
alarm system can only reduce the risk that this happens.