LEARNING AND MANAGEMENT OF RADIO DEVICES
For learning and device management follow the instructions and procedures in the specific
documentation of the Alarm Panel in use
You will have the following menù:
ENABLING AND DISABLING RADIO DEVICES
LEARNING A NEW RADIO DEVICE
DELETING RADIO DEVICES
CHANGING A RADIO DEVICE
LINKING THE RADIO INPUTS TO THE WIRED INPUTS
RESET DATA RADIO EXPANSION
MOUNTING AND CONNECTION
Using a screwdriver cross, open the cover ( fig.1 point 1).
Separate the rear cover and secure it to the wall.
Set the dip-switch HWADR depending on the setting numbers required by your installation ( see
technical manual of the Control unit ).
Connect the power and data wires making sure not to leave residue on the copper loop; the
cabling operation must be done in the absence of power ( the failure to comply with these details
can result in equipment malfunction or even break ).
Close by placing the front in the clips on the bottom of the cover, then secure the front cover
through the screw fastening.