AMBROGIO 6060BA0, User Manual, Page: 23 / 30

23 User’s manual
EN
ORDINARY MAINTENANCE
MAINTENANCE RECOMMENDATIONS
Important
During maintenance operations, use personal protection equipment indicated by the Manufacturer, especially
when working on the blade. Before carrying out any maintenance, make sure the robot is turned OFF (see
“Robot Safety Stop”).
SCHEDULED MAINTENANCE TABLE
Frequency Part Type of maintenance Reference
Weekly
Blade
Clean and check the
efficiency of the blade. If the
blade is bent or very worn,
replace it
See “Robot Cleaning”
See “Blade Replacement”
Battery charging knobs Clean and remove any rust See “Robot Cleaning”
Contact plates Clean and remove any rust See “Robot Cleaning”
Rain sensor Clean and remove any rust See “Robot Cleaning”
Monthly Robot Clean the robot See “Robot Cleaning”
Once a year and at the end
of the mowing season
Robot
Have the robot serviced at
an authorised service centre
See “Prolonged inactivity
and restarting”
ROBOT CLEANING
1. Stop the robot safely (see “Robot safety stop”).
Warning – Caution
Use protective gloves to avoid the risk of injury.
2. Clean the outside surfaces of the robot with a sponge using warm water and mild detergent. Wring the sponge out well to
remove any excess water before use.
Warning – Caution
Do not use a water hose to clean the robot. Water could get inside the robot and damage the components.
3. Do not use solvents or benzene so as not to damage the painted surfaces and plastic components.
4. Do not wash the internal parts of the robot and do not use jets of pressurised water so as not to damage the
electric and electronic components.
Warning – Caution
In order to not cause irreversible damage to the electric and electronic components, do not immerse the
robot, in water because it is not watertight.
5. Check the lower part of the robot (cutting blade area and wheels) and remove any deposits and/or residuals that may obstruct
the correct functioning of the robot.
6. To remove any deposits and/or other residuals from the blade, use a suitable brush.
7. Clean the knobs of the battery charger and removeany deposits or residuals caused by electric contacts with a dry cloth and,
if necessary, with fine sandpaper.
8. Check the level of sharpness of the cutting blade. If necessary sharpen.