18
2. Assembly
Instructions.
2.2.2 Turbulators
All models include a turbulator or a set of
turbulators. Carefully insert turbulator(s) inside
the tube up to the end tab.
2.2.3 Brackets
2.2 Assembly
Notes.
2.2.1 Tubes
Each heating unit has two types of emitter
tubes. See Table 7a and 7b of this manual.
Identify and position tubes on saw horses.
All
tubes should be positioned with seams
facing down when installed.
Position coupling
fastener so that these cannot be seen from
beneath the heater.
3” heater versions have a 4” diameter burner
spigot welded at one end. Ensure this tube
assembly is correctly positioned as shown on
the assembly drawings.
Where necessary, mark out the position of the
bracket centres from the dimensions shown on
the assembly drawings.
PLEASE READ this section prior to
assembly to familiarize yourself with the
components and tools you require at the
various stages of assembly. Carefully open the
packaging and check the contents against the
parts and check list.
The manufacturer reserves the right to alter
specifications without prior notice.
Please ensure that all packaging is
disposed of in a safe environmentally
friendly way.
For your own safety we recommend the
use of safety boots and leather faced
gloves when handling sharp or heavy items. The
use
of
protective
eye
wear
is
also
recommended.
Phillips
Screwdriver
Saw
Horses
Leather
Faced
Gloves
Tape
Measure
5/16”
Drive
Cordless
Drill
Wrench
Set
2.1 Tools
Required.
The following tools and equipment are advisable
to complete the tasks laid out in this manual.
Suitable alternative tools may be used.
Please read these assembly notes in
conjunction with the correct assembly
drawings (figs 10 to 27).
3/16” (5mm)
5/32” (4mm)
Allen wrench
Turbulator lengths and positioning
inside the tube vary between models.
Always ensure correct turbulator is
fully inserted into the correct tube
and from the correct end. Failure to
ensure this practice could cause the
heater to fail.
Turbulator dimensions and positioning
are indicated on individual assembly
drawings (fig.10 to fig.27).
Always ensure correct bracket is
used. Bracket type and positioning are
indicated on individual assembly
drawings (fig.10 to fig.27).