Helpful Advice Before Fitting
a) Please retain all packaging until you have checked and counted all the parts and the contents of
the fixing pack against the parts list.
b) The fixing pack contains small items which should be kept away from young children.
c) We suggest that you open the fixing pack and place all the contents into a container, therefore
reducing the risk of losing any small pieces.
Installation
（
Wall mounting
）
a) Do not connect the appliance until properly fixed to the wall and the instructions is read fully.
b) The minimum distances must be observed.
c) For installation of the appliance, care must be taken not to damage concealed cables.
d) Please be careful while drilling the holes.
e) This appliance is designed to be permanently fixed to a wall at a minimum height of 18”. The
wall bracket must be fitted horizontally and the cable routed to the bottom right of the heater.
f) A height of 36” from bottom of heater to floor is recommended for optimum viewing of fuel
bed
（
see fig.1 for recommend fixing dimensions
）
.
g) Use the bracket as table template and mark five drill positions on the wall. Make sure that these
holes are level. Observe the recommended fixing dimensions (Fig. 2).
h) Put the bracket aside and drill holes with a depth of 1” using an 8 mm drill bit.
i)
Clean the holes from dust and insert one plug in each hole. Make sure the edge is flush with the
surface.
serial
number
name
quantity
001
Carton
1
002
Screws ($4 x 8 mm)
2
003
Screws ($4 x 35mm)
2
004
Fixed Angle
1
005
Plastic plug($ 8 mm)
2
006
Packing left bubble
1
007
fireplace
1
008
bracket 1
009
Plastic plug($8 mm)
5
010
Screws ($4x35 mm)
5
011
remote control
1
012
Packing right bubble
1
013
Power cord
1