3
Pairing
Button
LED Indicator
Slider
Installation Instructions
Wall Switch Installation
Step 1: Prepare Wall Box Wires
1.
Make sure that the ends of the wires from the wall box are straight (cut if needed).
2.
Strip the wire insulator for each wire inside the wall box as shown here:
Strip the wire insulation from each wire.
Strip 5/8”(1.6 cm)
Wall box
1.
A standard single-gang wall box sized 3 x 2 x 2 ½ cm will service Dimmer
2.
Not compatible with multi or double Mud Rings.
3.
When using a retrofit gang box (cut in box) you might need to recess the ears.
If you are installing more than one Wall Switch unit, all
others must be switched Off while pairing.
1. Make sure both sliders are set to the top and the
Wall Switch is switched Off.
2. Switch the power ON at the circuit breaker, the
green LED Indicator will light up.
3. Turn ON the Wall Switch, the green LED Indicator
will blink
while pairing.
5. After up to 15 seconds, your LED fixture will be
paired with the Wall Switch.
6. To verify pairing is successful, move the sliders and
ensure that the LEDs respond accordingly.
7. If youre installing a smart wall switch Scan the QR
code to download the app. Follow the instructions
to connect to the SmartAir App.
* If pairing is not successful press the pairing button.
Note:
A maximum of 7 LED Drivers can be controlled with each Wall Switch.
Maximum Load
Input Voltage
120VAC
Max Load
700W
Pairing
Step 2: Wire Wall Switch
Wiring Description
(Using wire connectors)
1
. Connect the green (or bare copper) wire from the wall box
to the green Wall Switch wire.
2.
Connect the line/hot wire from the wall box to the black Wall Switch wire.
3.
Connect the black LED Driver wire to the red Wall Switch wire.
4.
Connect the white wire from the wall box to the white LED Driver wire
and the white Wall Switch wire.
Connect wires according to the wiring diagram below.
Red
Green
Ground
Black
Neutral
White
Line / Hot
120 V~
50/60 Hz
Wall Switch
(In-Wall Dimmer)
LED Driver
(Load)
Step 3: Mount the Wall Switch
Mount the Wall Switch into the wall box using the screws
provided.
Step 4: Restore Power
1.
Turn the power ON at the circuit breaker.
2.
Verify 120V with a Voltmeter
ON
OFF
Before You Begin
To avoid fire, shock, or death, turn the power Off
at circuit breaker and test to ensure
the power is Off before wiring.
ON
OFF
Connect to the SmartAir App
•
Scan the QR code to download
the App. Follow the instructions to
connect to the SmartAir App
