50D0093 Rev 3 May 2005
Page 9 of 11
Ambient Technologies
A Division Of
Low-battery detection:
1.
Battery voltage is checked once
a minute. When the battery
voltage drops to a certain level,
the low-battery warning will
come on, and the transmitter
will emit three (3) beeps and
send signals to
turn off the
appliance
. The transmitter will
not function anymore until new
batteries are installed. If the
battery is too low, the three (3)
beeps may not be heard.
2.
When the batteries are low, the
LCD shows a blinking low
battery indicator.
3.
Change the battery every six
months before the battery is too
weak for normal operation.
TURN THE UNIT OFF BEFORE REPLACING BATTERIES.
Touch Light Transmitter Thermal Shutdown:
1.
If transmitter measures a room temperature
exceeding 99 degrees Fahrenheit, the LCD will
display “HI”, emit three (3) beeps and send an
off signal to
turn off the appliance
.
2.
Transmitter will not function until the room
temperature has dropped below 99 degree
Fahrenheit.
3.
If transmitter measures a room temperature less
than 40 degrees Fahrenheit, the LCD will
display “LO”, and
no signals will be sent to
turn on the appliance.
Receiver:
Slide Switch:
1.
ON position: the system will remain on until the slide switch is placed in the OFF or RS position.
2.
RS position: the system will only operate if the remote receiver receives a signal from the transmitter.
3.
OFF position, the system is off.
The slide switch should be placed in the OFF position if you will be
away for an extended period of time.
If the remote receiver is mounted out of children’s reach, the OFF
position also functions as a safety device by both turning the system off and rendering the receiver
inoperable.
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1.
Light your gas appliance following the appliance lighting instructions that came with the appliance.
Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas
valve. Appliance control knob must be in the ON position. Appliance ON/OFF switch must be in OFF
position.
2.
Slide the 3 position button on the remote receiver to the ON position. The main gas flame should ignite.
