Version 2.0
©Copyright 2020, Ambient LLC. All Rights Reserved.
Page 35
http://www.ambientweather.com/stprraga.html
Make sure you periodically clean the rain gauge funnel.
6.11
Restoring the Console to Factory Default
To restore the console to factory default, perform the following steps:
1.
Remove the power from the console by removing the batteries and disconnecting the AC
adapter.
2.
Apply power by connecting the AC adapter.
3.
Wait for all of the segments to appear on the screen, as shown in Figure 18.
4.
Press and hold the
WIND/+
and
PRESSURE/-
buttons at the same time until the console
power up sequence is complete (about 5 seconds).
5.
Replace the batteries.
6.12
Resynchronize Wireless Sensor
Press and hold the
LIGHT /SNOOZE
button for 5 seconds, and the console will re-register the
wireless sensor.
6.13
Backlight Operation
6.13.1
With AC Adapter
The backlight can only be continuously on when the AC adapter is permanently on. When the AC
adapter is disconnected, the backlight can be temporarily turned on.
Press the
LIGHT SNOOZE
button to adjust the brightness between High, Low and Off.
6.13.2
Without AC Adapter
To reduce power consumption, the console will sleep on battery power only, and will not send data to
the Internet.
To temporarily turn on the back light for 15 seconds, press the
LIGHT SNOOZE
button.
6.14
Tendency Arrows
Tendency arrows allow you to quickly determine of temperature or pressure are rising and falling in a
three hour update period, updated every 30 minutes.
Figure 30 defines the conditions for rising and falling pressure every 3 hours.
Tendency indicators
Condition
Humidity Change per
3 Hours
Temperature Change
per 3 Hours
Rising
Rising > 3%
Rising > 1º C / 2 ºF
Steady
Change ≤ ±3%
Change ≤ ± 1 º C /
2 º F
Falling
Falling > 3%
Falling > 1º C / 2 ºF
Figure 30