50D0112
RCSTEBA Installation & Operating Manual
Rel 1.0 April 2009
Page 5 of 10
Ambient Technologies
A Division Of
Monessen Hearth Systems
Back of the Transmitter
Battery
Door
Tab
Remote Transmitter
:
Installing Batteries:
The remote transmitter uses three (3) “AAA”- size batteries.
To install batteries,
1.
Press down the battery door tab and pull out to remove the battery door.
2.
Install the batteries as indicated on transmitter.
3.
Close the battery door by snapping in place.
4.
When three batteries are installed, the transmitter will initialize for 10
seconds and then is ready for use.
5.
The batteries should be replaced at least once every 6 months or when the
low battery icon indicator is displayed.
Setting Privacy (DIP) Switch on Receiver and Transmitter:
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1.
There are four switches on the transmitter and seven switches on the receiver (see figure below). Switches
#1, #2, #3 and #4 on both transmitter and receiver are privacy switches and #5, #6, #7 on the receiver are
blower switches.
2.
Slide the privacy code switches (#1, #2, #3 and #4) on the transmitter and receiver to your choice of ON
or OFF position. All switches are preset to “ON” for both the transmitter and receiver.
3.
The privacy code switches(#1, #2, #3 and #4) on the transmitter and on the receiver must match in order
for the system to work.
4.
To check, press either the On or Off button on the transmitter and the receiver indicator light will blink. If
not repeat step 2.
5.
The system is now ready to operate.
NOTE
See the optional 6 hour shutdown section and the blower type selection section.
Receiver
Privacy Dip Switch (Need to match)
Transmitter
