ENTER
user only and retain running time by holding down both buttons 3
seconds or move cursor right to enter time domain. Set time in a similar manner
to user and enter time by pressing the two buttons simultaneously. Displayed
time is entered and also selected user bits. To change time while retaining user
move cursor through user domain to reach time or move cursor left into time
domain. Don't change user on the way!
The setting mode can be terminated at any time by closing the clapper. the
clapper will show old time and user.
Setting with external timecode
Plug in the external timecode through the lemo socket. The generator LED will go
red then green. Withdraw the external timecode on the green Phase. After 5
seconds the generator will be jamsynced again.The LED will go red then green
again. After the external timecode has been removed the green led must continue
blinking. The generator will change to the framerate entered.
Setting with ASCII.
Connect Ambient controller or Aaton Origen C to clapper with ASCII blue
Cable.Initiate ASCII or tune process.The led will change to green. Remove cable.
1.6 Reader
Clapper functions remain the same
Set DIP switch to reader and framerate
Connect external timecode.
Display will show timecode up to 1.5X speed
1.7 Clapper function
Open clapper,Time displays. Shut clapper, user bits display. After 5 seconds
display shuts off.The display can be reversed to show userbits then time.
Press button, time is displayed. release button, time changes immediately to user
bits and a buzzer sounds from the moment of changeover for 300 mS. The display
shuts off after 5 seconds. The display can be reversed,
1.8 Permanent display
Open clapper. Time shows
Shut Clapper.Set dip switch to permanent Display.Time shows
1.9 External Slate extension.
Move battery slider to expose slot
Slide in slate extension. Lock with battery slider.
use board marker and dry wipe clean.
1. 10 Changing batteries
Use only alkaline batteries duracell or equivalent
the batteries can be change without losing time the internal battery backup runs
for 5 minutes. this backup is also used to cover momentary loss of battery contact
should the clapper be dropped shaken or the sliding lid inadvertently opened.
