Wiring Instruction
1. The standard power supply ranges from 9V to 36VDC Please use the power cord
manufactured by the original factory. Red line means positive side while black line means
negative side. During installation, negative side should connect to the ground, do not
connect with other ground wires at the same time.
2. ACC line (orange) connects to vehicle's ACC switch, detecting ignition on and off.
3. Device's oil and electricity control line (yellow) connects to relay's 86. (thin yellow line of
relay socket)
Relay wiring instruction
Relay wiring way of oil pump open circuit: On each end of the wire is thin white line (85)
and thin yellow line (86). Thin white line (85) connects to the positive side of battery (12V)
while thin yellow line (86) connects to the device relay control. There is an oil pump in the
vehicle. Cut off the positive line. The positive side of oil pump connects to the dose-end of
relay.(Thick green line 87a), and the other side connects to relay's common(green thick 30).
Notice
12V relay is standard. The device is suitable for vehicles with 12V battery. If the
vehicle has 24V battery, then 24V relay is needed.
4. To monitor analog signals, the purple line (ADC) of extended port
5. To check status of car door, orange line (IN 1) should be connected
to where between the
door light and door switch (See the diagram).
6. To find car remotely, please connect the yellow line (OUT1) of extended port to external
relay.
Device Installation
Summary of Contents for Amber Power C210
Page 1: ......
