background image

IMPORTANT SAFETY INFORMATION! 

WARNING

 

When using electrical appliances basic precautions should always be followed to reduce the 

risk of fire, electric shock and injury to persons, including the following:

 

Read all instructions before using this heater.

This heater is hot when in use. To avoid burning, do not touch hot surface. If provided, use 

handles when moving this heater. Keep combustible materials, such as furniture, pillows, 

bedding, papers, clothes, and curtains at least 1 m from the front of the heater and keep them 

away from the sides and rear. In order to avoid overheating, do not cover the heater.

Extreme caution is necessary when any heater is used near children or the infirm and  

whenever the heater is left operating and unattended.

Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has 

been dropped damaged in any manner, return heater to authorized service facility for 

examination, electrical or mechanical adjustment, or repair.

Indoor use only, do not use outdoors.

This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. 

Never locate heater where it may fall into a bathtub or other water container.

Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar 

coverings. Arrange cord away from traffic area and where it will not be tipped over.

To disconnect heater, turn controls to off, then remove plug from outlet.

Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this

may cause an electric shock or fire, or damage the heater.

To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft 

surfaces, like a bed, where openings may become blocked.

A heater has hot 

surfaces 

and arcing or sparking parts inside. Do not use it in areas where 

gasoline, or

 

flammable liquids are used or stored.

Use this heater only as describe

d

 in this manual. Any other use not recommended by the 

manufacturer may cause fire, electric shock, or injury to persons.

DANGER-HIGH Temperatures may be generated under certain abnormal conditions. Do not 

partially or fully cover or obstruct the front of this heater.

Replacement of the 

LED

s should only

 be done

 

by a qualified technician or service agency 

while 

the heater is disconnected from the

 

supply circuit.

This appliance is not intended for use by persons (including children) with reduced physical, 

sensory or capabilities, or lack of experience and knowledge, unless they have been given 

supervision or instruction concerning use of the appliance by a person responsible for their 

safety. Children should be supervised to ensure that they do not play with the appliance.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this 

appliance must not be supplied through an external switching device, such as a timer, or 

connected to a circuit that is regularly switched on and off by the utility.

Do not use outdoors.

Do not use in immediate surroundings of water, bath, shower, or pool etc. 

Summary of Contents for BEF-50BIF03















Reviews: