Amazing Roller Shutters SE14.21 CP 970, Installation Instructions Manual

Page: 13 / 18

13
8.
OPERATING STATUS DISPLAY
Report Description Measure to solve the problem
Missing jumper
Insure jumper is in 2.1 & 2.2 on CP970
Missing jumper Insure jumper is in 21 through 26 on DES Limit
Emergency stop activated
Check the emergency stop is activated, or whether the supply cable is
broken
Missing jumper
Insure jumper is in 2.1 & 2.2 on CP970
Missing jumper Insure jumper is in 2.1 & 2.2 on CP970
Safety edge not recognized Check the safety edge is connected correctly or the wrong type has been
selected in the program
Photocell activated Check the photocell has been fitted properly, or whether the connecting
cable is broken
Safety edge operated in two
consecutive cycles Check for an obstacle or the connecting cable is broken or there is a short
circuit in the cable
Safety edge 8K2 activated Check the safety edge is activated or there is a short circuit in the
connecting cable
Safety edge 8k2 defect Check safety edge and connecting cable are not broken
Consult factory
Limits not adjusted Adjust limits
Safety open limit operated
Turn mains supply OFF and move the door downwards - with the manual
operator- until the limit is free or the open limit should be re-adjusted.
Safety close limit operated Turn mains supply OFF and move the door upwards - with the manual
operator- until the limit is free or the close limit should be re-adjusted.
Door load monitor has activated
Check to see if the door moves freely.
Missing jumper
Insure jumper is in 2.1 & 2.2 on CP970
ROM - Fault
Fault acknowledgement: switch OFF and ON the main power.
Internal fault report Fault acknowledgement: switch OFF and ON the main power.
RAM - Fault Fault acknowledgement: switch OFF and ON the main power.
Internal control fault
Fault acknowledgement: switch OFF and ON the main power.
DES
– no response
Check electronic limit DES connection. Fault acknowledgement: switch OFF and
ON the main power.
Drive unit does not work Check the do or m o v em e nt . Check the limit shaft for turning. Check phase
rotation.
Phase rotation failure Check main supply phase rotation turns right
Solution: Reverse 1 & 3 on DC970