System Set-Up
1.
IMPORTANT: When you connect the Camera to the Monitor, the power
must be off otherwise both units may be damaged.
2.
Screw the Camera to the Reel Cable (See Figure1- A) and connect the Reel to
the Monitor (See Figure 1-B).
3.
Put the Fuse into the jack located at the side of the Battery Box.
4.
Plug the Power Adapter Cord into the wall AC socket and the other end into the
DC 12V-Input Jack on the Monitor (if a Wall Adapter comes with your device
and see Figure 1-C); if you choose to use the charged battery, plug the power
output cord of the battery to the DC 12V-Input Jack of the Monitor, then press
the button on the Battery. The user can also charge the battery while using the
device in the following way: plug the Charger to the wall AC socket and the
other end to the jack on the Battery, and connect the power output cord of the
battery to the DC 12V-Input Jack of the monitor, then press the
battery’s button.
Note :
Don
’t misuse the power cord and battery charger cable , otherwise the
system can not work properly, or the battery pack may be damaged.
5.
Press the
POWER
button on the front of the monitor.
6.
Gently lower the Camera into a pipe duct, etc and reel out the cable until it is at
the desired depth.
7.
Press the
LED
button on/off and adjust LED brightness from the MENU.
8.
Record the pictures if you need for the models featured with DVR (see
recording operation
).
9.
By using a video cable you can transfer the picture to other larger Screen.
10. When you finish the job, carefully remove the Camera from the pipe duct, etc.
Screw out the camera head and clean it with a clean, soft and dry cloth and
then put the camera into the previous position.
Figure 1
7
A