If the PA-1009 becomes unstable during the course of
flying, you may need to calibrate the internal gyros. To do
this place the PA-1009 on a flat level surface. Long press
calibrating
button. The LEDs on the PA-1009 will flash
quickly and then remain solid, this indicates your
helicopter has been recalibrated (see diagram F).
CALIBRATING THE PA-1009
5
6
FLIGHT CONTROLS
While you’re learning to fly your helicopter, it is best to start with a large room until you get used to
the basic controls.
Roll the Throttle wheel forward to increase the speed of the main rotor, and roll the Throttle wheel
backwards to decrease the speed of the main rotor. The helicopter will rise or descend accordingly.
Tilt the controller forward and the helicopter will move
forward.
Tilt the controller left and the helicopter will spin counterclockwise.
Tilt the controller right and the helicopter will spin clockwise.
Tilt the controller backward and the helicopter will move backward.
SPEED CONTROL
: Your PA-1009 helicopter can operate in beginner (slower) or advanced (faster)
speed mode. Simply press the Speed Button to switch the speed.
AUTOMATICALLY TAKE OFF / LAND
Make sure you have properly synced The PA-1009.
• Simply press the “Throttle wheel/start & land” down on the controller, your PA-1009 will automati-
cally take off.
• To stop or land the PA-1009 just press the “Throttle wheel/start & land” down again and the PA-1009
will descend and land automatically.
F