NITID S12W
Dec 2022
9
Amate Audio
3. CONFIGURATIONS
3.1. Parallel connection
Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for
further units. All of
the units in this
chain
must
be
switched on.
For
the
mains
connection use the
cable with the blue
PowerCon.
You can use the
mains connection in
parallel by using a
cable
with
grey
PowerCon at one
end and the blue
PowerCon at the
other end.
Fig. 8.
Parallel connection for S12W cabinets (signal and mains)
Do not connect NITID series units using PowerCon without earth.
Do not connect more than ten units using the AC output link connector.
3.2. Parallel connection with other equipment
You can connect other NITID S full-range loudspeakers in parallel with the S12W.
Please, follow the same parameters as explained in Fig. 8.
4. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinet systems, it is strongly recommended
to carefully read the following advices.
4.1. S12W with full-range systems
The S12W incorporates a M20 base-plate on its upper side for the attachment of a
standard 35 mm diameter bar.
