Amantii WM-2134 Installation And Operating Instructions Manual Download Page 4

IMPORTANT INSTRUCTIONS 

WARNING 

You should read and always follow the important instructions below to reduce the risk of fire, electric 
shock, and injury to persons. 

1.  Read all instructions before using this fireplace. 
2.  This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as 

surfaces near the heater outlet or light bulbs. The grill directly in front of the heater outlet becomes 
hot during heater operation. Keep combustible materials, such as clothes, pillows, furniture, bedding, 
papers and curtains at least 3 feet from the front of the unit. Do not cover or block heater outlet or 
any ventilation or exhaust opening at any time. Do not use on soft surfaces where openings may 
become blocked. 

3.  Extreme caution is necessary when any heater is used by or near children or invalids and whenever 

the heater is left operating and unattended. 

4.  Do not install the fireplace directly on carpet or a similar surface,  which may restrict air circulation 

beneath the unit. 

5.  Always unplug fireplace when not in use. 
6.  To disconnect fireplace, turn controls to off, then remove plug from outlet. 
7.  Do not use outdoors. 
8.  This fireplace is not intended for use in wet locations, such as bathrooms, laundry areas and similar 

indoor locations. Never locate fireplace where it may fall into water container. 

9.  Do not operate the fireplace with a damaged cord or plug, or if the fireplace has malfunctioned, or if 

the fireplace has been dropped or damaged in any manner. Return fireplace to authorized service for 
examination, adjustment or repair. 

10.  Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange 

cord away from traffic area and where it will not be tripped over. 

11.  Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause 

an electric shock or fire, or damage the firebox. 

12.  To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft 

surfaces, like a bed, where openings may become blocked. 

13.  All electrical heaters have hot and arcing or sparking parts inside. Do not use it in areas where 

gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to 
flammable vapours. 

14.  Do not modify this fireplace. Use it only as described in this manual. Any other use not 

recommended by the manufacturer may cause fire, electric shock or injury to persons. 

15.  Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. 

However, if you have to use an extension cord, the cord shall be 

16AWG 

minimum size and rated not 

less than 125V/15A or 2500 watts. 

16.  Do not burn wood or other materials in this fireplace. 
17.  If the supply cord is damaged, it must be replaced by a special cord or assembly available from the 

manufacturer or its service agent. 

18.  Do not strike fireplace glass. 
19.  Always use a certified electrician should new circuits or outlets be required. 
20.  Always use properly grounded, fused and polarized outlets. 
21.  Always use ground fault protection where required by electrical code. 
22.  The heater must not be located immediately below a socket-out. 
23.  Always disconnect power before performing any cleaning, maintenance or relocation of the fireplace. 
24.  When transporting or storing the fireplace and cord, keep in a dry place, free from excessive 

vibration and store so as to avoid damage. 

25.  WARNING: In order to avoid overheating, do not cover the heater. 
26.  This appliance is not intended for use by persons (including children) with reduced physical, sensory 

or mental capabilities, or lack of experience and knowledge, unless they have been given 
supervision or instruction concerning use of the appliance by a person responsible for their safety. 

27.  Children should be supervised to ensure that they do not play with the appliance. 
28.  Indoor and household use 
29.  CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance   

must not be supplied through an external switching device, such as a timer, or connected to a circuit that 
is regularly switched on and off by the utility

 

Summary of Contents for WM-2134












Reviews: