Amano PIX-3000x Series, Manual

Page: 12 / 24

8
PIX-3000x Options Manual
Master/Slave and Signal Output PCB Installation
1. Unplug AC power cord.
2. Use the key to remove the
cover case.
3. Disconnect the batteries.
4. Use a Philips screwdriver to
remove the two screws
holding the inside cover.
5. From the front of the PIX,
grasp the two tabs on the
right and left side of the
inside cover and gently
hinge it backwards.
6. Remove the two rivets
holding the battery bracket.
7. Remove the battery
bracket.
8. Remove the two rivets that
secure the shield.
9. Place the board on the
battery bracket as shown.
10. Secure the board with four
rivets.
11. Reinstall the battery bracket
and secure it with two
rivets.
12. Plug in the 6-pin connector
on the options board to the
6-pin connector on the
power board.
13. Reinstall the inside cover,
taking care not to damage
the programming buttons.