5
Safety Precautions
Anyone operating the machine should read the
following carefully and be informed of potentially
dangerous operating conditions. Operators should
be familiar with the location and use of all safety
devices on the machine. DO NOT use the machine
if it is not in proper operating condition, and report
any damage or operation faults immediately.
DANGER!
Failure to read the Owner’s Manual prior to operating or
attempting any service or maintenance procedure to your machine
could result in injury to you or to other personnel; damage to the
machine or to other property could occur as well. You must have
training in the operation of this machine before using it. If you or
your operator(s) cannot read English, have this manual explained
fully before attempting to operate this machine.
DANGER!
To reduce the risk of fire, use only commercially
available floor cleaners, strippers, and waxes intended for machine
application.
DANGER!
Risk of explosion. Floor sanding can result in an
explosive mixture of fine dust and air. To reduce risk of explosion,
use floor sanding machine only in well ventilated area.
DANGER!
Operating a machine that is not completely or fully
assembled could result in injury or property damage.
DO NOT
operate this machine until it is completely assembled. Inspect the
machine carefully before operation.
DANGER!
Electrocution could occur if maintenance and repairs are
performed on a unit that is not disconnected from the power source.
Disconnect the power supply before attempting any maintenance or
service. Always remove the electrical plug from the electrical outlet
before changing the brush, pad or other attachment and before
leaving the machine.
DANGER!
Using a machine with a damaged power cord could result
in an electrocution.
DO NOT
use the machine if the power cord is
damaged.
DO NOT
use the electrical cord to move the machine.
DANGER!
Grinding of concrete and other materials with silica in the
composition may give off dust or mists containing crystalline silica.
Repeated and/or substantial inhalation of airborne crystalline silica
can cause serious or fatal respiratory diseases, including silicosis. In
addition, California and some other authorities have listed respirable
crystalline silica as a substance known to cause cancer.
DANGER!
This machine should only be used to wet grind and polish
concrete and other materials containing silica. Dry grinding will
increase exposure to crystalline silica.
WARNING!
Water solutions used with this type of machine can
leave wet areas on the floor surface. These areas can cause a
dangerous condition for the operator or other persons. Always put
“CAUTION” signs near the area being cleaned.
WARNING!
Modifications or alterations to this machine can lead
to personal injury or damage to the machine.
DO NOT
make
unauthorized modifications or alterations to this machine. Amano
Pioneer Eclipse assumes no liabilities for injury or damage resulting
from an unauthorized modification or alteration to the machine. Any
unauthorized modification or alteration to this machine voids all
warranties.
WARNING!
Electrical components of this machine can “short-out” if
exposed to water or moisture. Keep the electrical components of the
machine dry. Wipe the machine down after each use. For storage,
keep the machine in a dry building.
WARNING!
Always use a three-wire electrical system connected to
the electrical ground. For maximum protection against electric shock,
use a circuit that is protected by a ground fault interrupter. Consult
your electrical contractor.
WARNING!
To prevent damage to the power cord,
DO NOT
let the
brush, pad, pad driver or wheels touch the power cord when the
machine is running. Always lift the cord over the machine.
DO NOT
pull the power cord to move the machine.
WARNING!
Operating a machine without observing all labels and
instructional information could result in injury or damage. Read all
machine labels before attempting to operate. Make sure all of the
labels and instructional information are attached or fastened to the
machine. Get replacement labels and decals from your authorized
distributor.
WARNING!
Sanding wood or varnish produces dust that could self
ignite and could cause injury or damage. Dispose accordingly.
WARNING!
Use of this machine as a step or furniture could result in
injury or damage.
DO NOT
use this machine as a step or furniture.
DO NOT
ride on this machine.
WARNING!
To avoid injury keep hands, feet and loose clothing away from all
moving parts of this machine.
WARNING!
Injury to operator or bystanders could occur if an abrupt
change in floor surface texture is encountered when using this
machine. Abrupt change in floor surface texture can cause a sudden
pulling motion by this machine. This sudden pulling motion can result
in loss of control of the machine which could injure the operator or
bystanders. Avoid motions that could cause machine to cross from
a smooth floor surface to a carpeted or rough texture floor surface
Avoid motions that could allow the machine to come in contact with
low obstacles, such as floor electrical outlets, door stops or entry
molding, etc.
WARNING!
Any alterations or modifications of this machine could
result in damage to the machine or injury to the operator or other
bystanders. Alterations or modifications not authorized by the
manufacturer voids any and all warranties and liabilities.
CAUTION!
The machine is heavy. Get assistance before attempting
to transport or move it.
CAUTION!
When draining liquids from the machine, follow all local
and federal waste disposal standards.
