10
Section - A
English - EN
How to Operate the Machine
WARNING
: Machines can cause flammable materials
and vapors to burn. Do not use this machine with or
near matches, fuels, grain dust, solvents, thinners, or
other flammable materials.
CAUTION
: This machine will operate only on the AC
frequency and electrical voltage shown on the name-
plate. Make sure you have the correct frequency
and voltage before connecting the power cord to an
outlet.
NOTE:
You must have training in the operation of this
machine before you use this machine.
Position of the Handle for Operation
Lift the lever to unlock the handle. Lower the handle to
the best position. Bend your arms and keep your back
straight. To fasten the handle, press down on the lever
with your foot. Hold the handle against your body for
the best control.
Operation
1. Unwrap the power cord and plug it into the properly
grounded outlet.
2. Pull up on the handle release lever (5). Move the
operator handle (4) downward until your arms are
almost straight. Push down on the handle release
lever (5) to lock it in place.
3. Hold one of the operator handle grips (1) firmly, push
the switch lever safety lock (2) and then compress
the switch lever (3) to start the motor.
4. Lift up on the operator handle (4) until the pad is flat
against the floor.
CAUTION! Immediately start moving the machine
back and forth. Keep the machine moving while the
motor is running to avoid damage to the floor.
Note: When the switch levers (3) are released, the
machine shuts off immediately.
How to Start/Stop the Machine
WARNING:
Never start a burnisher when the handle
is in the vertical position.
The switch to start and stop the machine is activated
by the interlock switch and the levers under the handle
grips (see Figure 9). To start the machine, follow this
procedure:
1. Lower the handle.
2. Lock the handle in the best position for operation.
(see Figure 8).
MANUAL - REAR VIEW - DUST CONTROL
Figure 8
Apply
Pressure to
Lock
6
3
5
2
1
Figure 7
MANUAL - FRONT VIEW - DUST CONTROL
4
Summary of Contents for PE225BU DUST CONTROL
Page 1: ...MANUAL FRONT VIEW DUST CONTROL Floor Burnisher PE225BU DUST CONTROL Operator s Manual...
Page 30: ......
Page 31: ......
