P
roduCT
S
PeCifiCATionS
P
roduCT
S
PeCifiCATionS
SS-PTAC50
www.goodmanmfg.com 3
2 www.goodmanmfg.com
SS-PTAC50
• Extended Heat Pump Heating:
Heat pump models will operate in the heating mode down to as low as 24°F out-
door ambient, providing additional hours of energy-saving operation.
• Zero Floor Clearance: The u
nit can be installed flush to a finished floor, if desired. (Some accessories do not have
zero clearance).
• 30-Second Fan-Off Delay: The f
an continues to run 30 seconds after the compressor has stopped in either cooling
or heat pump mode and after electric heat has been turned off. This improves efficiency by dispersing the
conditioned air on the coils into the room.
• Compressor Lock-In:
This feature helps prolong the life of the compressor by preventing short-cycling. When
the compressor is switched from Off to On because room temperature has risen or fallen below the speci-
fied limit, it will remain on for at least 4 minutes. If the temperature set-point is changed during this 4
minutes, the lock-in feature is overridden.
• Automatic Emergency Heat:
No more “my unit is not heating” complaints during the middle of the night. Heat
pump units will automatically switch over to electric resistance heat if the heat pump compressor system
fails or if the heating load is greater than the unit capacity.
• Fan Mode Switch:
Take advantage of each unit’s dual options — select continuous fan operation or cycle the
fan ON and OFF with the thermostat.
• Reduced Outdoor Sound Transmission:
With our STC (Sound Transmission Coefficient) rating of 27, we keep out-
door sounds out of doors. By installing the optional STC 30 Rating Accessory Kit, ratings can be increased
to STC 30, thereby meeting or exceeding most ratings requirements. (Kit ordered separately.)
• Hidden Ventilation Control:
The ventilation control lever is hidden from the occupant's view to allow you to
manage ventilation requirements.
o
PTionAl
A
CCeSSory
Wall Sleeve
(14
⅛
” x 42” x 16
1
/16”):
No more worries about changing out non-standard sleeves that do not accommodate
the bulk of what the industry has to offer. Our wall sleeve is an industry-standard size of 14
⅛
” deep x 42” wide x
16
1
/
16
” high. (Please Note: Wall Sleeve must be ordered separately.)
S
TAndArd
f
eATureS
(
ConT
.)
