6
16. Rehang doors by positioning bottom sockets onto
bottom door hinge pins. Position so doors are flush
with sides of refrigerator cabinet. Handle side of
doors should be approximately
1
/
8
inch (3.2
millimeters) higher than hinge side of doors. Doors
will settle when loaded with food. On dispenser
models, when replacing freezer door, thread water
tube through bottom hinge pin and water tube clamp.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
17. Tape doors shut using masking tape.
Important
• Ensure trim pieces adhere properly by confirming
surfaces are clean, dry and free of adhesive
residue.
• Discard factory installed trim and handles.
18. Replace top hinges by placing top hinges on
refrigerator. Insert and tighten screws. On
dispenser models, reconnect top hinge wire
connectors. Install new top hinge covers by placing
hinge covers over hinges. On dispenser models,
carefully place wires under cover to avoid pinching
wires. Insert screws and tighten.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, green
ground wire must be attached to freezer
door hinge.
19. Install new bottom door handle caps by pushing up
into bottom of new handles until caps snap in place.
20. Install new door handles by placing door handles on
door. Insert and tighten screws. Install new handle
inserts by snapping in place.
Thin Section
21. Remove thin section on top handle end caps to
allow room for panels. Discard section. Replace
top handle end caps by placing end caps on
handles. Insert and tighten screws.
22. Dispenser Models
Replace dispenser cover by snapping in place.
Insert and tighten screws. Replace switch by
snapping in place.
23. Install new top door trim by placing trim on top of
doors. Insert screws but do not completely tighten.
When installing HTK200E and HTK220E, install new
color coordinated screws taped to trim.
24. Dispenser Models
Install new dispenser trim on freezer panels by
sliding trim on bottom edge of upper freezer door
panel and top edge of lower freezer door panel.
25. Slide decorator door panels into place until panels
are secure under door handle inserts.
Important
Permanent, double-sided tape is used to attach some
trim pieces to refrigerator. Before removing paper backing,
check placement of trim pieces on refrigerator. Trim
pieces may be damaged if adjustment or removal is
attempted after installation.
