Example:
With Alarm 2 set to trail alarm 1, if
A1Hi
is set to
1000
and
A2Hi
is set to
50
then Alarm 1 will activate at
1000
and alarm 2 will activate at
1050
(i.e. 1000 + 50). If Alarm
2 had been set at
-50
then alarm 2 would activate at
950
(i.e. 1000 – 50).
5.10
Display brightness
Display:
brGt
Range:
1
to
15
Default Value:
15
Displays and sets the digital display brightness. The display brightness is selectable from
1
to
15
,
where
1
= lowest intensity and
15
= highest intensity. This function is useful for improving the
display readability in dark areas or to reduce the power consumption of the instrument. See also
the
duLL
function. To set brightness level go to the
brGt
function and use the
^
or
v
push
buttons to set the value required then press
F
to accept this value.
5.11
Display remote brightness switching
Display:
duLL
Range:
0
to
15
Default Value:
1
Displays and sets the level for remote input brightness switching, see
R.INP
function. When a
remote input is set to
duLL
the remote input can be used to switch between the display brightness
level set by the
brGt
function
and the display brightness set by the
duLL
function. The
display dull level is selectable from
0
to
15
, where
0
= lowest intensity and
15
= highest intensity.
This function is useful in reducing glare when the display needs to be viewed in both light and
dark ambient light levels. To set dull level go to the
duLL
function and use the
^
or
v
push
buttons to set the value required then press
F
to accept this value.
Example:
With
duLL
set to
4
and
brGt
set to
15
and the
R.INP
function set to
duLL
the
display brightness will change from the
15
level to
4
when a switch connected to the remote input
terminals is activated.
5.12
Bargraph low value
Display:
bAr_
Range:
Any display value
Default Value:
0
Seen only in bargraph display instruments. Displays and sets the bar graph low value i.e. the value
on the 7 segment display at which the bargraph will start to rise. This may be independently set
anywhere within the display range of the instrument. Note: The
bAr_
and
bAr~
settings are
referenced from the 7 segment display readings, not the bargraph scale values. The bargraph scale
may scaled differently to the 7 segment display. For example the bargraph scale may be indicating
percentage fill of a tank whilst the 7 segment display is indicating actual process units. To set
bargraph low level go to the
bAr_
function and use the
^
or
v
push buttons to set the value
required then press
F
to accept this value.
22 of
PM4IVTMAN-2.3-0