Amada ADF4, Installation And Operation Manual

Page: 16 / 34

© 1999 Amada 16
7.1.2 Filter Cartridge Installation
1. Install the new filter cartridges gasket end
first.
2. Wipe off access cover gaskets and reinstall
the access covers. Tighten securely by hand.
3. The dust collector is now ready to start. Turn
electrical power ON at source and turn the
compressed-air supply ON before starting.
7.2 Dust Removal
Turn unit OFF and empty container as
necessary to keep the dust in the bin to a
minimum.
7.3 Original Equipment Filter Cartridge
(See Replacement Parts List)
The filter cartridges provided by Amada are the
only replacement filter cartridges that will
provide the high level of performance that you
expect from your investment in the dust
collector.
7.4 Compressed Air Components
1. Periodically check the compressed air
components and service by installing new
compressed air filters and draining any
moisture off by following manufacturer's
instructions.
2. With the compressed air supply turned ON,
check the cleaning valves, solenoid valves,
and tubing for any leakage. Replace any
components that are leaking compressed air.
See the Replacement Parts List.
NOTE
• Do not drop or rap the filter cartridge
on the floor or any other hard surface.
Damage to the filter cartridge will occur
and result in leakage.
• It is necessary to clean the dust off the
filter cartridge support panel around
the opening and around the access
cover gasket to ensure a positive seal of
the new filter gasket.
• Insert new filter cartridge gasket-end-
first, facing toward the clean-air section
or leakage will occur.
• Access cover knobs must be securely
tightened. Lack of filter-cartridge gasket
compression can cause leakage.
Turn compressed air supply OFF and bleed
lines before performing service work.
NOTE
Do not let the dust storage container
overfill. It can cause poor collector
performance and create an extensive
cleanup due to overflow of dust when
removing the container.
CAUTION