AM.PM PRIDE F7P00000, Manual

Page: 5 / 28

Operating interval of pressure in water
supply network 0,5–6,0 Atm. (50–620 kPa).
Recommended pressure interval in water
supply network 2,0–5,0 Atm (206–515 kPa).
Difference of cold and hot water pressure
should not exceed ± 10 %. In case
of deviation of water supply system
values installation of devices for pressure
increase / reduction is required.
To avoid mechanical (abrasive) particles
penetration inside the product it is
100–300 mk.
MIXER INSTALLATION
1. Disconnect hot and cold water supply
system
2. Remove (screwloose) aerator (to avoid
included into the delivery set.
4. Connect mixer to the water supply
system). Switch on water supply system.
Check leakproofness of all connections
during mixer closed position. When
necessary arrange additional tightening and
sealing of connections (when closing valves
of supply pipelines are closed).
000
5. Open cold and hot water supply for short
period of time (for washing of pipes), then
close the water supply and install (screw
tight) the aerator.
Operating interval of pressure in water
supply network 0,5–6,0 Atm. (50–620kPa).
Recommended pressure interval in water
supply network 2,0–5,0 Atm (206–515 kPa).
Difference of cold and hot water pressure
should not exceed ± 10 %. In case
of deviation of water supply system
Bath/ShowEr mIxEr , ShowEr mIxEr (For INStallatIoN oNto vErtIcal SurFacE)
F7 P 10000
F7 P 90000
F7 P 20000
pressure parameters to the specified
values installation of devices for pressure
increase / reduction is required.
To avoid mechanical (abrasive) particles
penetration inside the product it is
compulsorily required to install filters of
100–300 mk.
F7P20000 / F7P20032 F7P10000 / F7P10032
F7P90000 / F7P90032
5