alzaTools AT-CBCS20V, User Manual

Page: 15 / 72

15 ENGLISH
• It is recommended to clean the device after each use.
• Do not use water or any other liquid for cleaning.
• Clean the tool with a brush or compressed air at low pressure.
• Do not use any cleaning agents or solvents as they may damage the plastic parts.
• Regularly clean the vents in the motor housing to prevent the unit from overheating. Do not clean
the vents by inserting sharp objects such as a screwdriver and other similar objects.
• If you find damage to the cutting disc, replace it immediately.
• The cutting disc must always be sharp.
• Always store tools in a dry place, out of reach of children.
• Store equipment with the battery removed.
REPLACING THE CUTTING DISC
• Using the supplied Allen key, unscrew the blade fixing screw (10) by turning it counterclockwise.
• To prevent the saw spindle from rotating, secure the spindle with the spindle lock button (12) when
unscrewing the screw that fixes the cutting disc (Fig. K).
• Dismantle the outer flange washer (9).
• Using the lower guard lever (5), move the lower guard (11) so that the upper guard (2) is hidden
as far inwards as possible (check the condition and function of the spring that pulls the lower pro-
tective guard at that time).
• Slide the cutting disc (8) through the hole in the saw base (16).
• Position the new cutting disc so that the teeth and the arrow on the blade align with the direction
of the arrow on the lower and upper guards.
• Insert the cutting disc into the base groove and mount it on the spindle so that it is correctly pressed
against the inner flange surface and centred.
• Install the outer flange washer (9) and tighten the blade retaining bolt (10) by turning it clockwise.
• After replacing the blade, always store the hex key in its storage location.
Observe the correct tooth direction when installing the cutting disc. The arrow on the saw body
shows the direction of rotation of the spindle.
Take extra care when holding the blade in your hand. Wear protective gloves to protect your hands
from the sharp teeth of the blade.
All defects should be repaired by a service centre authorized by the manufacturer.
MAINTENANCE AND STORAGE