Always “On” UPS Systems Inc.
M0102_V_Series_801-222V_Manual V2.3 2012-06-12
3
1
REPLACE BATTERY indicator (RED LED)
This LED illuminates when the UPS's batteries are no longer useful and
must be replaced.
Note: When replacing the batteries, disconnect the utility power and then
open the case. Take notice of the polarity before installing the new
batteries to avoid a short.
2
BUCK AVR (VOLTAGE REDUCTION) indicator (YELLOW LED)
This LED illuminates when the UPS is correcting a high utility voltage
condition. The loads receive normal power.
3
BACK-UP indicator (YELLOW LED)
This LED illuminates when the UPS is supplying battery power to the
loads.
4
BOOST AVR (VOLTAGE BOOST) indicator (YELLOW LED)
This LED illuminates when the UPS is correcting a low utility voltage
condition. The loads receive normal power.
5
LINE NORMAL indicator (GREEN LED)
This LED illuminates when the line-input voltage is normal. (RM version;
also flashes to indicate Backup mode)
6
ON/OFF/TEST/SILENCE button (TEST / SILENCE for GES-102VR).
Press and hold the button for more than 3 seconds to turn the UPS “ON”
or “OFF” (not applicable to GES-102VR). Press and hold the button less
than 1 second to activate a self-test, or silence the back up alarm.
7
UPS OUTPUT SEGMENT 1 ON / OFF SWITCH
This switch allows independent ON / OFF control of UPS output segment
1 outlets on rear panel.
8
UPS OUTPUT SEGMENT 2 ON / OFF SWITCH
This switch allows independent ON / OFF control of UPS output segment
2 outlets on rear panel.
9
BYPASS ON/OFF SWITCH
This switch allows independent ON / OFF control of the surge-protected
outlet on rear panel. (This outlet is not supplied backup power in the event
of a power outage)
10
MAIN POWER
This toggle switch is the main power cutoff for the UPS. Use of this
switch will remove power from loads and completely shutdown the UPS.
