Alvarion BreezeMAX PRO-S CPE, Product Manual

Page: 71 / 162

Installing the 3.5 GHz Detached Antenna
BreezeMAX CPEs Product Manual 49
2.4.4 Wall Mounting the 3.5 GHz Detached Antenna,
with Tilt & Pan Capabilities
The installation kit includes the following:
„
2 M3*8 Screws (1)
„
2 M3 washers (2)
„
Antenna back plate (4)
„
U-Joint Set (adjustable arm) (5)
„
4 5/32-16*1TP Wall Screws (6)
„
4 ¼" Wall anchors (7)
„
Grounding Wire (8) - Not Used
1
Attach the adjustable arm to the wall following the directions in Figure 2-18 .
2
Assemble the antenna to back plate with supplied screws and washers.
3
Screw the back plate to the adjustable arm following the directions in
Figure 2-18 .
4
Remove the cap from the antenna connector located on the bottom side of the
antenna and connect the cable. Use only the torque key supplied with the
antenna. Do not over tighten. Do not use a wrench or a similar tightening tool.
5
Align the antenna by releasing the spike knob located next to the base bracket.
The bracket's arm can be adjusted sideways or tilted up and down. Position
the antenna such that it faces the base station cell site. Tighten the spike knob
to lock the antenna into position.
6
Check your receive signal strength (RSSI) LEDs in the Si CPE to ensure the
antenna is optimally aligned. If necessary, re-align antenna following the steps
described above.