Alva GBL003, Assembly And Operating Instructions Manual

Page: 6 / 23

4
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your BBQ and causing
injury to yourself, others and to property.
1. Assemble
There are no spare parts supplied with this BBQ. Once fully assembled you should have
no spare parts left unused.
the BBQ following the assembly instructions carefully.
2. Connect the gas hose and regulator to the BBQ. Ensuring a gas tight seal.
3. Connect the regulator to the cylinder valve.
4. Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the
appliance.
LIGHTING YOUR BBQ
Lighting Instructions:
1. Connect the gas cylinder to the BBQ.
2. Turn all the control knobs to the ‘OFF’ position.
3. Turn ‘ON’ the gas supply at the cylinder. Do a leak test before operation as follows:
Check with a 50/50 soap water solution by brushing the solution on all joints.
Any bubbles showing will indicate a leak. Re-tighten clamps or connection nuts.
If a leak persists do not use the BBQ . Consult your local dealer.
5. Always light your BBQ in sequence from left to right.
6. If the burner has not lit after two attempts, turn gas control to ‘OFF’ and wait 5 minutes
before retrying the ignition sequence.
7. If the burner does not stay alight, please repeat step 3.
8. Once the burner is lit adjust the heat by turning the knob to the High/Low position.
9 . To turn ‘OFF’ the BBQ, close the cylinder valve and turn all of the control knobs on the
appliance clockwise to the “OFF” position once the flames have extinguished.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight following the
the correct ignition sequence from left to right.
4. To light the left hand burner, push down the left hand control knob and keep pressing whilst
turning anti-clockwise to the “Full” position whilst pressing the left ignition button sited between
the left and centre knobs up to four times in rapid succession. This will light the left hand
burner. If it fails to light please repeat this process. Repeat this process using the left ignition
button and the centre knob to light the centre burner. To light the right burner, use the same
procedure, using the right ignition button and the right knob. You can also light the centre and
right burners by pushing down the middle control knob while turning it anti-clockwise to the
“full” position. The burner will cross ignite from the burner to its left. Repeat this process using
the right burner once the centre burner has ignited. Adjust to the required heat setting.