Installation Instructions
4 / 11 / 2022 / Rev 1
1170 N Red Gum St, Anaheim, CA 92806
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
aluz.lighting
866.ALUZ.LTG | 714.535.7900
A8 Series
|
LED Tape
ZIZA
Standard
(A8-ZIZA-STN)
Page 7 of 12
Mounting Fixture
(Dry Location Mounting Channel)
Countersink hole
Lens overlapping
Two extrusions meet
Countersink screw
Extrusions aligned
Remove adhesive backing
Install lightstrip into extrusions
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting channels.
5
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
3
Screw extrusions to surface using countersink screws.
Note:
Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
7
Perform a continuity test before connecting luminaire to power source.
2
Lay extrusions along chalk line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
6
Install lens into extrusion, overlapping where two extrusions meet. Plan
your cuts so that the lens will always overlap where two extrusions meet.
Overlapping lenses helps keep extrusions aligned and prevents light leaks.
4
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note:
Refer to Application Guidelines to ensure correct installation.
