ПРИВОД LG-500 | LG-500 DRIVE)
69
ADjUSTMENT
DELETING THE REMOTE CONTROL
AND DEFINING OF THE RECORD NUMBER OF THE REMOTE
The
table 10
describes the settings, it is used when there is a remote control but the information
for the remote control number in the drive memory is not available.
1
Press and hold the button
for about 5 secs to enter the
programming mode
2
After the appearance of ‘
P1
’
inscription press the button
3
After the appearance of ‘
P2
’
inscription press the button
4
With the button
or
select the required setting:
‘
F7
’—defining the number of the remote control;
‘
F8
’—deleting the remote control
5
After the appearance of required setting (‘
F7
’ or ‘
F8
’) press the button
6
‘
rc
’ is shown on the display, which means that a signal from the remote control
is expected
7
Press the selected control button 3 times
8
The display will automatically show the number of the remote control in the
drive memory. If the remote control is not recorded, ‘
no
’ will be shown on the
display
9
To set ‘
F8
’ press the button
. A dot will disappear from the display, this
means that the remote control with the selected number is deleted from the
memory
10
In three seconds the switch to the waiting mode for the signal from the next
remote control will take place. To exit the programming mode press the
button
or wait for 15 seconds (until automatic exit the setup menu)
Table 10
Summary of Contents for LG-500
Page 2: ......
Page 10: ...ПРИВОД LG 500 LG 500 DRIVE 8 Рис Мал Fig 27 Рис Мал Fig 28 ...
Page 81: ......
