10
Changing the fuse:
Turn off the power.
Remove the control box cover
(Figure 4).
Open the fuse holder cover.
Replace the defective fuse with a similar one: F - 6.3A (Fuse FU,
Figure 1
).
Put all the items back in place.
Average service life of the product is 8 years with the intensity of work up to 30 cycles of «opening-closing» per day. After the
expiration of the established service life, it is necessary to address to the Supplier for reception of the conclusion on admissi-
bility of the further operation of the product.
9. SERVICE
The control unit must be subjected to scheduled service to ensure efficient and safe operation. Planned service must be car-
ried out in strict compliance with the applicable regulations and safety measures. Planned service must be carried out at least
once a year:
Check the control unit and components (cables, buttons, electronic components, etc.). Damaged parts must be replaced.
Clean the outer surfaces of the control unit. Clean with a soft, damp cloth. Do not use water jets, high-pressure cleaners,
acids or alkalis for cleaning.
Check the proper operation of the controls (control unit buttons, remote controls and optional controls).
Check that the connected motor is working properly.
At least once every six months, check the correct operation of each connected safety and alarm device.
10. WAREHOUSING, TRANSPORTATION AND RECYCLING
Warehousing of products shall be effected in packaging in closed and dry premises. Do not allow exposure to precipitation or
direct sunlight. Storage period is 2 years from the production date. All types of closed aboveground transport can carry out
the transportation with the exception of shocks and movements inside of transport.
Recycling should be performed according to regulatory and legal acts about utilization and recycling used in the
country of consumption. The product does not contain precious metals and substances that are dangerous to life,
health and the environment.
The packaging must be disposed of in accordance with current regulations.
11. WARRANTY
1. The Seller guarantees full operability of the product when it is used in full compliance with the user manual, if the mounting
process is carried out by an Organization that has been authorized by the Supplier.
2. During the warranty period, faults caused by the fault of the Manufacturer or the organization authorized by the Supplier
that installed the product, shall be eliminated by the Supplier.
3. The warranty does not apply in cases involving:
failure to comply with installation, operation and use regulations;
installation, adjustment, repair, reinstallation or modification of the product by persons not authorized by the Supplier;
damage to the product caused by unstable operation of the power supply network or mismatching of the power supply
network with the values set by the Manufacturer;
force majeure (fires, lightning strikes, foods, earthquakes and other natural disasters and emergencies);
occurrence of malfunctions and defects caused by the inoperability of roller shutter systems.
the fields in paragraphs 12 and 13 of this manual are not fully filled in.
Note: parts replaced under warranty become the property of the Supplier.
4. The warranty period is 2 years and is calculated from the date of installation.
EN