Series 248-2 Assembly Instructions
Dated 11/2021 Previous instructions become invalid.
7 /
12
•
Now continue to connect the various lights:
•
To
wire the LED strips
with
motion detectors (infrared sen-
sor)
, fit together only
1.
the connectors and push
2.
the plug-in
connection downwards into the
left-hand frame pillar
.
•
To
wire the LED strips
without
motion detectors
fit together
only
1.
the connectors and push
2.
the plug-in connection
downwards into the
left-hand frame pillar
.
Note:
The figure shows wiring with LED strips on the right
and/or on the left-hand side.
•
Fix the gusset plate in the corner pillars with 3 M 10 x 30 countersunk
screws MD100268 positioned on each side (tightening torque
60 Nm ± 5 Nm).
•
Screw the roof from the top using 3 - 4 screws on each side
MD100318 together with ring seals MD110044 uniformly distribut-
ed, each from the front to the back. Set the screwdriver tightening
torque to 5 Nm ± 1 Nm.
Attention:
To maintain the sealing function, the sealing washer
must not be pressed out from under the screw head by
more than approx. 0.5 - 1 mm!
•
Measure the diagonals of the frame and correct them if necessary,
until they match each other.
•
Screwing the remaining screws MD100224, M 6 x 21 mm Tx 30 to
a tightening torque of 10 Nm ± 1 Nm vertically into the side
walls-front wall connection, until the sections are pressed together.
•
Fill the remaining cavity between the front wall and side wall panel
with the piece of cut foam supplied.
•
Then close off the vertical front inside body corners with the corner
covers using the rivets MD150023.
•
Screw the remaining screws MD100318 with the ring seal MD110044
into the connection of the roof and walls. Again, pay attention to
deformation of the sealing washer (see above).
•
Tighten the screws MD100268 of the frame gusset plates at the top
as well as the screws M 12 x 45 mm, MD100307 of the frame cross
member to the required torque of 125 Nm ± 5 Nm.
Attention:
The rear surface of the two crossmembers must form a
flush plane with the rear surface of the pillars.
•
Now seal the component crossovers of the frame.
•
Remove the single-stud fittings from the roof assembly rails.
•
If necessary, screw the inside right handle onto the frame pillar.
•
Close off the side screw holes in the rear pillars using the plugs supplied.
0.5-1
correct
wrong
wrong
MA 350081
MA 350081
MA 3
50120
MA 350081
MA 3
5012
0
Power IN cable
Power IN cable
Roof edge
MA 3
5011
4.
..19
,
MA 3
501
41
MA 3
50114.
..19,
MA 3
50141
LED strip, right
LED strip, left
1
2
Roof edge
MA 3
5011
4...1
9, MA 3
5014
1
MA 3
5011
4...1
9, MA 3
5014
1
MA
350127
MA 350081
Power IN cable
MA 3
50081
MA
35012
6
1
2
Driv
ing direc
tion
Driv
ing direc
tion
