4
We reserve the right to any technical change. Valid on 2019.04.12
DC 661 PROGRAMMING MANUAL
2.3. Settings days and hours for automatic controls
We only change the lifting and lowering time in the automatic control mode.
The difference between lifting and lowering must not be less than 32 minutes.
If the pause between each key press is longer than 10 seconds, the transmitter exits the setting mode. Leaving the time change
mode without saving is carried out by pressing the STOP key
Press and hold the „MODE / K„
By pressing the „MODE / K-” -button
By pressing the „MODE / K-” key, you
Press the „MODE / K-” button again.
By pressing the „P2” button, you go
By pressing the „OK / K +” button in
Press and hold the „MODE / K”
The operation of the ”UP” and
The operation of the „UP” and
The operation of the „UP”
After setting all operating
After setting all operating
button for 3 seconds to switch on
you can change to the
go to the minute settings of the
The lift time will flash
to the hour settings of the reduction
1 or 3 mode you change the days of
button for 3 seconds.
„DOWN” keys changes
„DOWN” keys changes
and „DOWN” keys changes
times you should keep the
times you should keep the
the automatic control
minutes settings
reduction times. The minute symbol
times.
the week. We repeat these activities
The lowering time appears on
the minute settings
the minute settings
the hour settings
„OK / K +” - button pressed for about
„OK / K +” - button pressed for about
will blink
to set the time
the display
3 seconds to confirm the changes
3 seconds to confirm the changes
