Page 5 of 8
4
Set the header bar and stopper assembly into the
wall mount bracket, from the top. Slide a Wall Mount
Cover [
G
] into the wall mount bracket. Tighten the wall
mount, and wall mount cover set screws [
H
] until the
header bar is secure. This will prevent rattles in the
header bar.
5
Locate the center of the sill at the middle of the
header bar. From the Center Guide [
I
] remove the
two Center Guide Inserts [
J
] to expose the mounting
holes. Using the center guide as a pattern, mark the
location for the two holes and lightly trace the outline of
the center guide on the sill. Drill two 5/16” holes. A little
silicone in the holes will help seal the holes and prevent
moisture from entering the sill. Place the center guide
anchors into the holes. Put a small bead of silicone
around the interior of the outline for the center guide.
Set the center guide in place and secure it with the two
Center Guide Screws [
K
]. Replace the center guide
inserts with the thicker legs to the inside of the center
guide.
6
Place the male portion of a Roller Cap [
L
] into a
top hole in a glass panel, in a neutral position as
shown. Attach a Roller [
M
] to the cap, using a Roller
Screw [
N
]. Screw the threaded Roller Cover [
O
] onto the
cap. Repeat for the other three top holes. The lower four
rollers will be installed later.
NOTE: The door glass can be adjusted, up or down, later
by removing the roller cover, loosening the roller screw
and rotating the cam action roller cap.
