Page 4 of 8
1
Measure one of the glass Door Panels [
A
] and subtract
4 1/2”. That is the distance up from the sill that you will
place the BOTTOM of the two Wall Mount Brackets [
B
].
Using a wall mount bracket as a guide, and holding it level,
mark the hole locations on the walls, making sure that it is
located so that the center guide can be installed properly in
Step 5 of this instruction. Drill the four holes 3/8” diameter.
Insert the four Wall Anchors [
C
] into the holes and attach
the wall mount brackets with the four Wall Mount Bracket
Screws [
D
].
NOTE: For an out of level sill, install the wall mount bracket
on the high side as described, and use a level and the
cut header bar (step 2) to locate and install the opposing
bracket.
NOTE: There are four large anchors and two smaller ones
used to mount the center guide in Step 5 of this installation
instruction.
OPTIONAL:
If the anchors are not used, Drill a 1/4”
diameter clearance hole, just through the tile and a pilot
hole into the wall stud. Install the wall mount brackets as
described above.
2
Measure the distance across the opening near the top
of where the shower door is going to be. Subtract 3/4”
and cut the Header Bar [
E
] to that length. File down any
burrs created by cutting the header bar.
NOTE: There are spacers placed down the length of the
header, between the two rectangular tubes. You will need
approximately 5 inches on each end with no spacers, to
get the Stoppers [
F
] positioned correctly. You may have to
make two cuts.
3
Slide two Stoppers [
F
] over each end of the header
bar, with the rubber bumper on the top side of the bar
and pointing towards the middle of the header bar. Do not
tighten the set screws at this point.
